|
Gal mainpage Ad below main pic
|
The wing slats and flaps are from Paragon set
No 48012, these were fitted using piano wire as srew jacks, I drilled matching
holes into the interiors and flaps and mounted the flaps as the last job.
Before cutting any plastic away from the kit parts check the resin parts
match the panel lines, if not, adjust with a file.
I used Compucolour Vietnam paints set and the Xtradecal
sheet No X 015-48
 |
|
The seats were modified as was the dashboard and
coaming.
|
Note the flower wire srew jack at the outer end.
My flaps were a little warped, but I plunged them in boiling
water until pliable then straightened them against a piece
of wood and plunged them under a cold tap. |
|
|
Paragon's big exhaust set No 48006 was used here
to make the "F" version used at the 'Heath.
|
|
 |
|
The underside ECM pod |
Ted
To see more of Ted
Taylor's models....go to
Ted
Taylor's Modelworks
|
Gal mainpage Ad above main pic
|
|
