Construction

The under carriage is nicely detailed broken down into 10 pieces for the main units (not including doors) but the shape of the main under carriage doors is wrong and a smaller door is totally missing.  This can be rectified with some cutting, sanding and scratch building of the missing door. I did not bother as I was happy the way it is.

The fuselage suffers from a few minor sink marks around the locating pins but is easily fixed with some putty.  The cockpit transparency is the standard Minicraft clear block which incorporates part of the fuselage skin around it to aid in getting the perfect join around the cockpit area.  I added the compulsory nose weight before fitting the cockpit piece.  Some sanding is required to get the piece in as it is a very tight fit.

The wings attach to the fuselage with the tongue and slot method, the difference here is that the tongues interlock with each other to give a stronger join to the fuselage and the opposite wing.  I cut the length down on these tongues as I found they tend to interfere with each other, and reducing their length by around 5-6 mm helps to get them seating better.  The flap extension/retraction jack fairings come molded on the wings which is good if you don't like fiddling with a lot of pieces during construction.  The downfall here is the shape of all these fairings is wrong.  They are molded with a squared off cross section where the actual item is more rounded.  This is corrected with a fair bit of filing and sanding to get the right shape.  I used reference photos from www.airliners.net (a great source of aircraft pictures both civil and military) to get the shape correct.

On to the engines, they assemble easily and come with an intake ring which eliminates the need to remove the intake seams you get with earlier kits.  The rear of the engine pylon suffers the blockiness of the flap jack fairings and needs to be attacked with files and sanding sticks.  Also some rescribing of lost detail is required.  The recess in the wing for the pylon is also too large so I used some thin evergreen card to line the forward part of the opening before attaching the pylon itself.  This reduced the gap and made a more snug fit for the engine attachment.  Some putty is still needed at the rear to reduce the remaining gap.

The horizontal stabilizers come as single pieces and need only a little clean up before attaching to the fuselage.  I added the antennae, drain masts and vortex generators on the inboard side of each engine nacelle from sheet styrene.

Well that's about it for construction, not many parts and fairly straight forward.  If you wish to make it more accurate then the effort to reshape the flap jack fairings and engine pylons is worth the effort.  Apparently Minicraft is aware of some short comings of the kit and has corrected some problems with the next release of the B777 boxed with Singapore Airlines and Delta markings though I believe the chunkiness of the fairings is still an issue.

Painting and Finishing

Painting was completed using Humbrol and Tamiya paints and SNJ metaliser for the leading edges and engine intakes and exhausts.  The decals came from an Egypt Air Airway Graphics sheet (windows, windscreen and doors) and the spares box (roundels, flags and tail number).  Everything was sealed with a few coats of Future.

In conclusion the small number of parts makes this a quick build, your time is mostly used on correcting mold errors and painting (got to love masking!).  This was a great little project and enjoyed it immensely.  Now I have to finish my non flight of fancy RAAF BBJ to go with it.   Back to the bench!!

Ray