This is the 1/48 Hasegawa F-16 kit built as a What If RAAF F-16CG Block 40. The paint scheme was inspired by a post in the What If Models thread by Trigger. The decals were leftovers from the AMT F-18 kit.
Click on
images below to see larger images
|
|
I
scratchbuilt the pitot tube and the scab plates. The scab plates
were made using aluminum tape based off stencils provided by Daniel Perez
Vertti. The intake pods and GBU-16s were from the Hasegawa weapons
set. The rest of the load out was OOB.
For the camo
scheme, I used Krylon River Rock and Camo Green for the topside, and
Krylon Pewter Gray for the underside. The main canopy section was
tinted using a mix of Tamiya Smoke and Yellow. The panel lines were
highlighted using Flory Models Dark Dirt wash.
Hope you
enjoyed this What If F-16.
Diamond
Click on
images below to see larger images
|
|
|