This is my Avro
Vulcan, I basically built it OOB. I did some research on the internet about the
kit and was aware of fit problems, especially with the wing / fuselage area .
Even so, I still managed to screw it up... I left the plane on the "Fix it
later graveyard" for about a month. I picked it up again and saw it might
be recoverable, "Bondo" came to the rescue, and I generously applied
enough to cover my sins, and then worked on the intakes, which looked smooth
after filler in the seams, and 3 or 4 coats of white auto primer.
The rest of the kit went well, I lost the entry door on the Vulcan but found
cutting up the lower nose section of a junk 1/48 F-106 did well as a door. I
applied 2 coats of white primer and 3 coats of white auto paint, I did not get
the brilliant white, but rather a "bone china white" or a very
slightly off white, which to me looked more appropriate. The decals were a
nightmare, thank goodness I had a spare set of decals ( from another Vulcan
which was demolished when my two cats decided to have a fight next to my
models). They did not react well (the decals..not the cats!!) at all to any kind
of setting solution, both Solvaset or MicroSol. Now all I have to do is make a
Victor in the same scheme!
Suresh
Click on
images below to see larger images
|
|
|
|
|